Link to HomeBrowse by Materials
Browse by Craft

Milliput Epoxy Putty


Milliput Epoxy Putty

+ click on image to enlarge

 

 

If provided, our colour charts are intended as an indication of colour only

 

Milliput Epoxy Putty

Milliput is a two-part, cold setting, non shrinking epoxy putty sold in cartons containing 113.4g (one 56.7g stick of each part).

It can be used for repairs and restoration on many types of materials including metals, plastics, masonry, wood, glass and ceramics and can be used in places where welding is impractical.  It is an exceptional modelling medium as once fully cured it can be machined, drilled, tapped, turned, filed, sawn, sandpapered and painted.

Milliput is an excellent adhesive and will bond any of the following to itself or to any of the others - wood, brick, cement, metals, concrete, plastics, glass etc, but note that Milliput is not intended as a thin layer adhesive. Milliput will set under water and is heat resistant up to 130°C.

Mix together equal parts of each stick from the pack. Knead and roll in the hands for at least 5 minutes until the colours merge and become uniform and no streaks can be seen, and then mix for another minute - the putty may cause irritation to sensitive skin and therefore rubber gloves are advised. The surfaces to which the putty is applied should be free from grease and dirt. Smooth surfaces should be cleaned with a suitable solvent or with soap and warm water to remove dirt and grease. Abrading the surface will improve adhesion. the putty may now be applied and will set hard in three to four hours without shrinking.

At all stages from initial mixing to final setting Milliput responds to the use of water. To aid manipulation and avoid sticking, fingers and tools should be kept moistened with water. There are certain instances when work may be carried out in a gentle stream of water under a tap. To obtain a smooth finish, mould or apply Milliput and then immediately wipe and smooth gently with wet finger or with a fine textured moist cloth.

Rinse rubber gloves and any tools immediately after use with soap and water.

Choose from five grades of Milliput: Standard (Yellow/Grey), Terracotta, Silver Grey, Black and Superfine White.

Price each (inc VAT) from: £4.00
Choose your colour or size:
Option:
Quantity:
Option:
Quantity:
Option:
Quantity:
Option:
Quantity:
Option:
Quantity:

back

Follow our pages on:
visit Facebook.comvisit Twitter.comsee our Blog